FERRICON is used in providing concrete floors, which has to carry heavy loads and traffic. This load causes Impact as well as abrades the floor topping. FERRICON being ductile and malleable resist this effect. It is available in 3 grades – i.e. Ferricon Metallic Floor Hardener, Ferricon NM – Non Metallic Floor Hardener and Ferricon QTZ – Quartz based Floor Hardener.

ADVANTAGE

FERRICON provides the following important features to the concrete surface: * Wear Resistant, * Spark Resistant * Non Dusting, * Easy to clean * Non-Slip, * Oil proof * Excellent resistance to dragging scraping point loads. * Extends serviceable life of the concrete floor. * Easy and economical to apply * Having hardness more than 8 to 9

AREAS OF USAGES

Industrial Floors, Run-Ways, Damp,-Spill Ways, Godown Floors, Ware Houses, Railway Platform, Shopping Centers Loading Bays, Trucking Lanes, Car Parks, Repair Workshops, Machine Shops, Ramps, Sliding & Rolling Work Places, Forklift Truck Movement, Crawler Tractor Traffic & Transporting Equipment with Steel Wheels, Taxi-ways, Weirs, Garage Floors, Parking Aprons, Jetty, Docks & Quays, Foundry Floors, Hangers, Duct & Silos, Concrete Roads, Causeways, etc.

FERRICON – NM is a very hard, non slip aggregate comprised of quality controlled, factory blended pure graded emery and special additives to improve workability.
Emery is a natural occurring mined material that is extremely hard, tough and abrasion resistant. As a result, proper installation of FERRICON – NM will impart long life and excellent skid resistance for concrete surfaces. FERRICON – NM is completely non corrosive used for inside and outside.

FERRICON-QTZ is a ready-to-use non-metallic floor hardener comprised of finely graded quartz aggregates, special additives and Portland cement. Proper installation of FERRICON-QTZ will impart long life and high durability to concrete floors. It can be used inside or outside and is completely none rusting.

Heavy Duty Epoxy Floor Topping Compound. EPIWELD-HF is a two component, 100% solids cross linking resin-epoxy system combined with specially graded and selected hard-wearing aggregates. Applied at an average 1 to 2 mm thickness to provide hard non-wearing topping.

EPIWELD-HF is especially recommended for providing floor toppings in Warehouses, Loading Docks, Garages, Gangways and Alley of Industrial Units subjected to heavy wear. It can be used for patching as well as resurfacing worn out concrete surfaces. It is resistant to acids, alkalis, grease, oil, abrasion and impact.

ADVANTAGES :

1. Excellent adhesion to a wide range of surfaces like Concrete, Stoneware, Steel, etc. will not lift, peel or chip. 2. Superior ability to withstand mechanical punishment and abrasion. 3. Surface is joint-less, dust-free, and non-slip. 4. Resists acid and alkali. 5. Excellent dielectric insulation qualities. 6. Lesser thickness does not interrupt adjoining areas. 7. No need of chipping old concrete. 8. Does not allow Bacterial growth.

CONMAST is a thermo plastic compound of selected fillers and blown grade Bitumen in powder form. When it is heated at about 200-300o C, the entire mass transforms into a sticky paste that could be trowelled easily on the surface. The treated surface is resistant to most diluted inorganic acid.